A giant photo frame prop to 3D print for New Year's Eve and weddings

The big frame guests hold round their faces is the busiest corner of any party. How to print one with the party's words and hashtag on a normal 256 mm printer, in eight pieces that press together, and how to sell it before December.

A giant photo frame prop to 3D print for New Year's Eve and weddings

A photo frame prop is an open frame that guests hold up round their faces, usually with the event's name across the top and a hashtag or date along the bottom. Three things decide whether it works:

  • Size. Two faces need roughly 40 cm of width; three people squeezed in need closer to half a metre.
  • Stiffness. It gets passed round all evening and held by one corner, so it must not sag or twist.
  • Lettering that reads in a photo. Short words, large letters and strong contrast between the words and the frame.

Most party frames are cut from foam board, polystyrene foam faced with paper, which is light and cheap but dents and creases easily. A printed frame is rigid, carries this party's words and can be stored for the next one.

The problem has always been size. A frame big enough for three faces is half a metre across, about twice the 256 mm build plate of a Bambu Lab A1, a common size for home printers.

Eight pieces that press together

The photo frame prop comes in eight flat pieces: four corners and four bars between them. Each corner ends in two dovetails that press into sockets in the bars' ends. A dovetail resists being pulled apart, which is why woodworkers use it for drawer fronts, and here it locks the frame flat. There is no glue and no screws, and it comes apart again to store.

The words sit on the bars, between the joints, so a seam never runs through a letter:

  • Across the top: HAPPY NEW YEAR, Emily weds James, MILA TURNS 5.
  • Along the bottom: the party's hashtag, so the photos can be found afterwards.
  • Up the sides: the year or the couple's names, reading up on the left and down on the right.

The corners carry the decoration: stars for New Year's Eve, hearts for a wedding or an anniversary, confetti for a birthday.

Printing it

At the default 540 by 400 mm, the pieces fit on three plates of a 256 mm bed: two corners and a side bar on each of the first two plates, the top and bottom bars on the third. Everything prints flat, face up, with one filament change where the words start, so a single-spool printer makes it.

Print at 4 mm thick so the frame stays stiff, and print one joint first to check the fit: the dovetail should press in with a firm push of the thumbs.

What to sell with it

A frame is the centre of a photo corner, so sell the corner:

Black and gold is the New Year's Eve look; ivory and maroon, or blush and gold, suit a wedding.

Selling tips

  • Post it in early November. Hosts planning New Year's Eve parties and winter weddings need time to approve the words and receive the frame, so list it well before December.
  • Rent it, too. Photographers and planners take a frame to every event; sell them one with neutral words, and hosts one with their own.
  • Show it in use. One photo of three people inside the frame shows its size far better than a flat lay.

The Christmas and New Year parties ideas page and the wedding favours page have the frame with example words, ready to open in the studio. Our post on New Year's Eve photo booth props covers the props and glasses.

Planning what to make next? Browse personalised print ideas by occasion, or work out prices, party orders and colour changes with the free maker tools.

Take your next custom order in minutes

Type your customer's text, send them a picture to approve, download a print-ready file.

Start selling

Keep reading